Char-Broil 463247109 Betriebsanweisung PDF herunterladen (Seite 9)

CAUTION

SPIDER ALERT!

VALVE

CONTROL PANEL

SPIDER WEBS

INSIDE VENTURI

If you notice that your grill is getting hard to light or that the

flame isn’t as strong as it should be, take the time to check and

clean the venturi’s.

In some areas of the country, spiders or small insects have been

known to create “flashback” problems. The spiders spin webs, build

nests and lay eggs in the grill’s venturi tube(s) obstructing the flow of

gas to the burner. The backed-up gas can ignite in the venturi behind

the control panel. This is known as a flashback and it can damage

your grill and even cause injury.

To prevent flashbacks and ensure good performance the burner and

venturi assembly should be removed from the grill and cleaned

before use whenever the grill has been idle for an extended period.

BURNER

SPIDER AND WEBS

INSIDE BURNER TUBE

Cleaning the Burner Assembly

Follow these instructions to clean and/or replace parts of burner

assembly or if you have trouble igniting grill.

1. Turn gas off at control knobs and LP cylinder.

2. Remove cooking grates and flame tamers.

3. Remove hitch pins and carryover tubes from rear of burners.

4. Remove Hitch pin to disengage burner from bracket on

firebox.

5. Detach electrode from burner with a flat screw driver by

pressing the electrode clamp out of the burner through the

notch on the clamp. Electrode should remain in firebox.

6. Carefully lift each burner up and away from valve openings.

We suggest three ways to clean the burner tubes. Use the one

easiest for you.

(A)

Bend a stiff wire (a light weight coat hanger works well)

into a small hook. Run the hook through each burner

tube several times.

(B)

Use a narrow bottle brush with a flexible handle (do not

use a brass wire brush), run the brush through each

burner tube several times.

(C)

Wear eye protection: Use an air hose to force air into

the burner tube and out the burner ports. Check each

port to make sure air comes out each hole.

7. Wire brush entire outer surface of burner to remove food

residue and dirt.

8. Clean any blocked ports with a stiff wire such as an open

paper clip.

9. Check burner for damage, due to normal wear and corrosion

some holes may become enlarged. If any large cracks or

holes are found replace burner.

VERY IMPORTANT: Burner tubes must reengage valve

openings. See illustrations at right.

10. Attach electrode to burner.

11. Carefully replace burners.

12. Attach burners to brackets on firebox.

13. Reposition carryover tubes and attach to

burners. Replace flame tamers and

cooking grates.

Electrode

Firebox

Carryover tube

Firebox

burner

bracket

Correct

burner-to-valve

engagement

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Char-Broil 463247109 Betriebsanweisung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barbrque & Grills Char-Broil 463247109